| The Motion Group, Inc. | |
| Home | About Us | Basics | Download | Links | Contact | Sitemap |
|
Stepper Motors Linear Actuators [PDF file - 700k] Ready-To-Steptm Black Box Systems - Single Axis - Multiple Axis OEM Card sets - Multiple Axis - Motor Drivers CNC Retro Kits Videos Software |
The PLC unit, combining a high-speed, high-power step motor driver with a matched power supply, requires only PLC inputs (step and direction), motor and AC line power. Any typical unipolar or bipolar motor, regardless of voltage, is connected to the output terminals of the PLC unit. Full, half or quarter step size and also micro-step is available depending on the card style installed. Max Output current; PLC 2.0 = 2.8A peak (2.0A RMS) per coil PLC 4.0 = 5.7A peak (4.0A RMS) per coil Max output current is dial-able (dial pot eliminates current measurements). Parking control reduces power during standstill for reduced motor heating. Over-voltage (Vmm and Vcc), over-current, over-temp and rev-polarity protection is standard. “DC OK” indicator lamp. The PLC Interface Package comes standard with an optically isolated translator-driver card, a 24 VDC motor power supply with fuse, filter and line cord. Standard input connection is an 8 pin screw terminal connector and outputs are 6 pin Molex. Others on request. Cooling is convection (no dropping resistors or fans). Mounting is by tapped holes from the bottom of the case. View Mechanical Specs. > |
| Home | About Us | Basics | Download | Links | Contact | Sitemap |